New & Renewable Energy Circuit Wiring Training Kit
KTE-7000SQ
Equipment Introduction
-
It is the thread wiring sequence control test system for controlling renewable energy generating test system, it can conduct the basic electric circuit practice, national skill certificate circuit practice, and also renewable energy generating system sequence control can be practice, and throughout screen, generating power can be monitored in real time.
-
Basic sequence education : Connects the thread wire with various new renewable device and banana jack, and by using sequence, after programming, it can be operated.
-
Various circuit sequence design practice : It uses relay (ry), push button switch (pb), select switch (s/sw), toggle switch (t/s), buzzer (bz), power lamp (pl), run lamp (rl), stop lamp (gl), so you can experience various new recycle device control sequence.
-
Safety : Dc24v input power is selected for safety thread wiring test and practice.
-
Simple wiring practice using banana jack : Not only wiring using wires, but inserting banana jack, easy and simple wiring practice is available.
Equipment characteristics
-
Sequence control practice device, for controlling renewable energy practice devices, allows basic electrical circuit practice and national technical qualification circuit practice.
-
Banana jack cables should be used to shorten wiring time and ensure safe practice.
-
36pin connectors can be connected and controlled with renewable energy generation systems.
- The solar energy generation system
- Wind energy generation system
- Solar and wind energy hybrid power generation system
- Photovoltaic hydrogen fuel cell power generation system
- Electrolysis hydrogen fuel cell generation system
-
It is made in the form of a bag, so it is easy to move and store.
-
Each device is manufactured in a detachable form and can be easily replaced in the event of a defect.
Education Contents
-
Practice to configure switch circuit
-
Practice to configure relay circuit
-
Practice to configure of lock up circuit
-
Using ATS automatic switch circuit for uninterruptible
-
Practice to configure of commecial electric or battery power selection circuit
-
Stand-alone inverter circuit configuration training for Solar street light
-
Hybrid systems and Grid connected inverter circuit configuration
Detailed Parts Configuration
(1) N.F.B / (2) N.F.B Terminal Base / (3) 8pin Relay / (4) 1a1b Push Switch / (5) Select Switch / (6) Toggle Switch / (7) Buzzer / (8) 24V DC Motor / (9) Signal port / (10) Timer (DC24V, 24Hour) / (11) Lamp / (12) 11pin Relay / (13) Terminal Base / (14) IC Timer (DC24V, 60sec, 8Pin) / (15) Flicker (DC24V, 60sec, 8Pin)
Equipment Configuration Diagram
-
Base sequence Education
- Available training and practicing of sequence control through load part (Lamp, Buzzer, and motor) that is installed interior of a air-conditioning refrigeration wiring training kit.
-
In case of each apparatus is connected
- Each refrigeration apparatus can work by connecting of a air-conditioning refrigeration wiring training kit that had been set up sequence circuit with real wire or banana plugs.
Composition of Control Parts
◈ 8-pin ◈
-
For control of compressor motor, condenser fan motor, solenoid valve, and evaporator fan motor of standard refrigeration.
◈ 60-sec delay timer ◈
-
After passing some determined time, the contact open or close.
◈ 60-sec flicker relay ◈
-
For the determined time, the contact keep opening or closing.
◈ 24-h timer ◈
-
For the determined time, the contact keep opening or closing.
Video Clips for Product Usage
AUTO CONTROLLERS AND THE TRAINING DEVICES
Proposal Educational Curriculum Solar & Wind Power Generation
